User Manual

TF2047903-MC-00-ENG Page 5 of 21 20161205 V.2
submerged. There must be a minimum of 3” (7.6 cm) between the water
level and top of the vessel.
(4) Remove the food product from the vessel and either mark the water
level on the side of the vessel or measure the amount of water in the
vessel.
(5) Remove the water and completely dry the vessel and the food product.
(6) This is the amount of cooking oil the vessel is to be filled with to cook
the food product.
10. Introduction of water or ice from any source into the oil/grease may cause
overflow and severe burns from hot oil and water splatter. When frying
with oil/grease, all food products MUST be completely thawed and
towel-dried before being immersed in the fryer.
11. Do not place an empty cooking vessel on the appliance while in operation.
Use caution when placing anything in cooking vessel while the appliance
is in operation.
12. In the event of rain, snow, hail, sleet or other forms of precipitation while
cooking with oil or grease, cover the cooking vessel immediately and turn
off appliance burners and gas supply. Do not attempt to move the
appliance or cooking vessel.
13. Do not move the appliance when in use. Allow the cooking vessel to cool
to 115°F (45°C) before moving or storing.
14. Do not leave the appliance unattended; keep children and pets away from
the appliance at all times.
WARNING
Installation Safety Precautions.
 Use appliance only with LP (propane) gas and the regulator/valve assembly
supplied.
 Installation must conform with local codes or, in the absence of local codes, with
the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Storage and Handling of
Liquefied Petroleum Gases, ANSI/NFPA 58; or Natural Gas and Propane
Installation Code, CSA B1 49.1.
 This appliance must be used only outdoors, and must not be used in a building,
garage or any other enclosed area.
 Use appliance at least 10’ (3 m) from any wall or surface. Maintain 10’ (3 m)
clearance to objects that can catch fire or sources of ignition such as pilot lights on
water heaters, live electrical appliances, etc. Never use under balconies made of
wood or ANY overhead construction.
 Apartment dwellers: Check with management to learn the requirements and fire
codes for using an LP Gas appliance at an apartment. If allowed, use outside on
the ground floor with a 10’ (3 m) clearance from walls or rails.
 Before opening LP tank valve, check the coupling nut for tightness. When
appliance is not in use, turn off control knob and LP tank valve.
 Never move appliance while in operation or still hot.