User Manual

Product No. 043-1016-6 | Contact us: 1-855-803-9313
6
General Use
1. Place the Blender on a clean, flat, dry and level surface.
2. NEVER run the Blender when the Jar is empty.
3. Add ingredients to Jar and push Lid securely in place before positioning on Blender Base. Unless instructed
otherwise, load first with wet ingredients and then dry ingredients. Always add ice and larger, harder ingredients
last. Make sure that the Cap is locked in position by turning it clockwise in the Lid.
WARNING: When adding warm liquids take care to prevent splashing and allow the liquid to stand for a few
minutes with Lid off to permit steam to escape.
4. While the Blender is off, place the Jar securely on the Blender Base.
5. Plug into a 120V AC grounded wall outlet.
NEVER attempt to set the Jar on or remove it from the Blender Base while the motor is running.
NEVER operate the Blender Base without the Jar properly positioned.
6. Set the Speed Control to minimum and turn on the blender. Slowly increase speed as required. The Jar may move
slightly as it locates on the Centering Platform. Let the Blender run until the desired consistency or temperature
has been reached.
7. If the contents stop circulating, DO NOT rock or shake the Jar while the motor is running. Using the Pulse
function or the Tamper will help. First, Switch the On/Off button to Off Position (O). Then either:
a) pulse on and off by pressing and releasing the Pulse Switch.
or
b) turn the Speed Control to the lowest setting, remove the Cap and insert the Tamper through the Lid opening.
DO NOT use Tamper for longer than 45 seconds as this may cause overheating.
DO NOT use this Tamper in any other appliance as this may damage your Tamper.
DO NOT use a Tamper from any other appliance in this Blender as this may damage your Blender.
8. If this does not work, press the On/Off Switch to the Off positon (O) to stop the motor. Once the Blades stop
turning, remove the Jar from the Blender Base and move the contents around with a rubber spatula. Return the
Jar to the Blender Base, replace the Lid/Cap and continue blending.
9. When blending is complete move Switch to the Off positon (O).
WARNING: Rotating blades can cause severe injury. Wait until the Blades have completely stopped rotating
before removing or reaching into the Jar.
10. Unplug from the wall outlet and remove the Jar by liing up.
WARNING: The Drive Socket, Locking Nut and Blades may become very hot aer extended use. DO NOT touch.
Allow to cool down before handling or cleaning.
NOTE: Tamper should not be used when the Jar is more than ¾ full. Switch to the On
position (I). Hold the Jar handle with one hand and with the other move the Tamper in both a circular
and up/down motion to unblock the contents of the Jar.
NOTE: The Blender Base has a safety switch hole for the pin on the bottom of the Blender Jar. The
Blender will not turn on if the Jar is not in place on the Base.