Specifications

Match-Lighting
Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP cylinder.
2. Push in and turn left burner knob to HI. Be sure burner lights and stays lit.
3. Place lit match into match holder, then into lighting hole on left side of grill.
Match Lighting Procedure
}Ì}ÊÌiÊÌiÀÊÃ`iÊvÊÌiÊ`Õ>ÊLÕÀiÀ\ÊOnce one side of the dual burner has
been lit, push in and turn the other control knob to ‘HIGH’. The unlit burner will
light automatically.
Shutting Down The Barbecue After Use
UÊ/ÕÀÊvvÊÌiÊ}>ÃÊVÞ`iÀÊÛ>Ûi°
UÊ/ÕÀÊÌiÊLÕÀiÀÊVÌÀÊÛ>ÛiÊÌÊÌiʺ"vvʻʫÃÌ°
This sequence is important as it prevents residual gas from being left in the system
under pressure and will make the next use easier.
7
WA R N I N G
If the heat output is too low, the flow control feature may have been acti-
vated by a gas leak or improper lighting procedure.
If so, turn off the burner valve and cylinder valve, and perform the “Leak
Test”. If there aren’t any leaks, re-light the burner.
WA R N I N G
Never stand with your head directly over the Barbecue when preparing to
light the main burners, to prevent possible bodily injury.
WA R N I N G
IF THE SELECTED BURNER DOES NOT LIGHT,
immediately turn the burner control knob and cylinder valve to the OFF
position, to prevent gas buildup. Wait five minutes for the gas to clear and
then repeat the preceding starting procedure. If the burner will not light
when using the ignitor, follow the match lighting instructions.
Use this slot for manual match-lighting