Specifications

L I G H T I N G
T H E B A R B E C U E
Prior to lighting your barbeque, visually check all hoses before each use, for nicks,
cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not
use your barbeque. A replacement hose and regulator is required.
UÊ>iÊÃÕÀiÊÞÕÊ>ÛiÊvÜi`Ê>ÊÌiÊViVÃ]Ê«ÀVi`ÕÀiÃÊ>`ÊÃÌÀÕVÌÃÊÊ>Ê
previous sections before attempting to light the barbecue.
Important
UÊÜ>ÞÃÊÀ>ÃiÊÌiÊL>ÀLiµÕiÊ`ÊLivÀiÊ}Ì}ÊÌiÊLÕÀiÀ°
UÊDo not lean over the barbeque when lighting in case of back flash.
UÊ>}ÊÃÕÀiÊÌiÊ>ÊL>ÀLiVÕiÊVÌÀÊLÃÊ>ÀiÊvv]ÊÃÜÞÊ>`ÊV>ÀivÕÞÊ«iÊ
the propane gas cylinder valve.
UÊ6ÃÕ>ÞÊViVÊÌiÊy>iÃÊiÛiÀÞÊÌiÊÞÕÊ}ÌÊÞÕÀÊL>ÀLiµÕi°ÊvÊÌiÊy>iÊÃÊ>L-
normally small or smokey yellow – shut off the barbeque and check the venturi
tubes for blockage or refer to the Troubleshooting Guide.
Using The Igniter To Light The Burner
ÃÕÀiÊLÕÀiÀÊVÌÀÊLÃÊÊÌiÊvvÊ«ÃÌÊLivÀiÊ«i}Ê}>ÃÊÃÕ««Þ°
1. Open the lid before lighting.
2. Open the gas supply valve and wait 5 seconds.
3. Push in and turn a single main burner control knob to ‘HIGH’.
4. Depress the Push button igniter.
5. If the burner does not light immediately (within four seconds), turn burner
control knob off and wait 5 minutes to clear the gas.
È°Ê,i«i>ÌÊÃÌi«ÃÊ£ÊÌÊx°ÊvÊLÕÀiÀÊÃÌÊv>ÃÊÌÊ}Ì]ÊÀiviÀÊÌÊÌiÊ/ÀÕLiÃÌ}ÊÕ`iÊ
to determine the cause and solution, or try the Match Lighting procedure below.
6
C A U T I O N
If ignition does NOT occur in 5 seconds, turn the burner controls OFF,
wait 5 minutes and repeat the lighting procedure.
If the burner does not ignite with the valve open, gas will continue to
flow out of the burner and could accidently ignite with risk of injury.