Specifications

DO NOT COMPLETELY TIGHTEN SCEWS UNTIL ALL

PARTS ARE IN POSITION AND CORRECT.

1A. All parts must be assembled at the same time using hardware

#5 screw (2) and #7 nut (2). Assemble the upper leg

support (FA), with the side brace (FJ) in position, to both

the front and rear left cart legs (FD and FE).

1B. Assemble the bottom brace (FG) (with notches to hold LP

tank facing upwards) to both the front and rear left cart legs

(FD and FE) using hardware #16 hinge pin (2) and #15

hitch pin (2).

DO NOT COMPLETELY TIGHTEN SCREWS UNTIL

THE ENTIRE CART IS ASSEMBLED AND CORRECT.

2A. Assemble the upper leg support (FA) to the both the front

and rear right cart legs (FB and FC) using hardware #5

screw (2) and #7 nut (2).

2B. Assemble the bottom brace (FG) (with notches facing

downward) to both the front and rear left cart legs (FD and

FE) using hardware #5 screw (2) and #7 nut (2).

3A. Attach the tank exclusion wire (EC) to the left and right

cart legs, as shown, ensuring that the large opening for the

tank is located on the left side of the cart.

3B. Assemble one of the rear braces (EA) in this step, to the

rear left and right cart legs (FD and FB) by removing the

two screws and flange nuts already assembled in the

previous step.

Upper Left Leg

Lower Left Leg

Notchs to hold LP cylinder

Tank Support Bracket

Support Bracket

Left

Right

Figure A

Figure B

Figure A

Figure B

Back view