User`s manual

Master Audio

Xcellence “E “Series. Ver1.0 Nov12

The connection panel has the following parts:

F) NETWORK: Computer connection through Ethernet protocol. Two 8-pin RJ45 /

EtherCon® compatible connectors with an internal switch allow the connection of

several units in daisy-chain. Please refer to Master Audio DSPStudio Quick Installation

Guide for more information on the remote connection.

G) BALANCED INPUT/LINK:

XLR-3 Female balanced signal connector for signal input.

XLR-3 Male connector for parallel connection of various cabinets with the same input

signal.

IMPORTANT: Please always use balanced microphone cable with the following pin

assignment:

1= Shield (Ground) 2= Live (+) 3= Return (-)

Fig.8. X18WE control and connection panel

H) AC INPUT/OVERVOLTAGE PROTECTION: These leds show the status of the

AC mains supply.

 ON: (Blue) When lit, the equipment is ON and the AC input level is within the

permitted range (up to 250 VAC).

 STANDBY: (Orange) This led is lit when the equipment is sensing the AC

voltage at the input. At power-up this led will lit for a second while the systems

checks for the input voltage.

 >250V OVERVOLTAGE PROTECTION: (Red) When activated, the AC

voltage is permanently out of the permitted range of the equipment

(>250VAC), so it will remain under protection until this condition is solved.

Revise your connections and mains power installation and consider that other

equipment connected to this line may have been damaged.