Specifications
OUTPUTS AND INPUTS
(quarter-inch phone jacks)
MONITOR OUTPUT
Unbalanced high-level output unaf-
fected by Input Channel controls
except INPUT ATTENUATION and
individual MONITOR. For separate
monitor amplifier system, or remote
amplifierlspeaker.
TAPE OUTPUT
Designed for connection to "TAPE
IN" on tape recorder or to aux input
of similar device.
EXTERNAL DEVICE LOOP
Additional information
MONITOR OUTPUT
HI
Z,
unbalanced, aux level, pre-
fader output, affected by MONI-
TOR EQ and MONITOR MASTER
controls.
TAPE OUTPUT
Unbalanced high-level HI
Z
out-
put is post-channel Volume con-
trols, and pre-master controls; may
be used without speakers con-
nected to the 1200's amplifier.
PROGRAM MIX OUTPUT AND POWER AMPLIFIER INPUT
These two
%-inch phone jacks allow an external equalizer or effects device such as echo,
delay, compressor, or noise gate to be connected between the PROGRAM MIX OUTPUT
and the POWER AMP INPUT. The PROGRAM MIX OUTPUT can also be used as a
post-MASTER VOLUME control send to an external amplifier, recorder, etc., without
interrupting the signal to the internal amplifier. The POWER AMPLIFIER INPUT allows
the 1200's internal amplifier to be used independently of its mixer section. Using the
POWER AMPLIFIER INPUT jack interrupts the program send to the power amp.
Post-
fader PROGRAM MIX OUTPUT is affected by all program input and output controls
except LIMITER; POWER AMPLIFIER INPUT is pre-LIMITER.
NOTE: The External Device Loop can be used to connect two 1200's together for an
expanded capability of 400 watts total speaker output power. Connect the PROGRAM
MIX OUTPUT of the first 1200 to the PROGRAM MIX OUTPUT of the second 1200. All of
the inputs to both 1200's will then appear at the speaker outputs of each. Set the channel
controls
normdlly. Each MASTER VOLUME control determines the level of all inputs at
its speaker outputs. When this procedure is followed, the MASTER VOLUME controls
will require higher settings to obtain the same level at the speakers because each
PROGRAM MIX OUTPUT loads the other. With appropriate MASTER VOLUME control
settings, the full 400 watt total speaker output power is available from the two Model
1200 power amplifiers.