User`s guide

Tutorials

Tutorial 3: Broadcasting

Wirecast User Guide | 104730

Motion only occurs during a transition (when you click Go, or click a shot in AutoLive

mode). Motion defines how to add (Build-In) or remove (Build-Out) a shot element.

There are two forms of Motion:

1. Build-In (add) Build-In motion occurs when the shot is added to the Live Broadcast

display.

2. Build-Out (remove) Build Out motion occurs when the shot is removed from the

Live Broadcast display.

Changing Motion Options

Click the menu under Build-In in the configuration area and select From Left. Also check

the Decelerate In checkbox:

To see this behavior in action, you must go back to the Main window and trigger the

Build-In action. To do this, follow these steps:

1. Close the Shot Editor window (optionally) by clicking the X in the corner of the

window.

2. In the Main window, make sure Smooth transition is selected.

3. Click on the Blank Shot, then click the Ripples shot (recently edited). Notice that

when the Title appears it comes in from the left.

Tutorial 3: Broadcasting

This tutorial demonstrates how to setup and broadcast your Wirecast presentations.

You can broadcast to a specific computer (Unicast), multiple viewers (Multicast), or

even record your broadcast to disk.

There are two main components for broadcasting your presentation (or saving it to

disk):

1. Encoding You need to decide how you are going to encode the broadcast.

Encoding is the type of compression used (JPEG, MPEG4, etc.). Wirecast comes

configured with many common encoding options.

2. Destination A destination for the broadcast must be selected. You can send it to a

server for broadcast or save it to disk.

Select “From Left”

Check Decelerate In