User`s guide

Using the Shot Editor
Shot Editor Playback
202
Wirecast User Guide | 104730
Transport Controls
The Transport controls enable you to Rewind, Play, Pause, and Fast Forward. If Live
Playback is checked, any changes you make using these controls are seen in your
broadcast.
In and Out Points
The In Point and Out Point controls are a part of the Playback settings. The In Point is
the position in the media where playback starts. For example, if you set the In Point of a
movie to 2 seconds, when the movie starts to play (or loops back to the start), it starts
from the 2 second point in the movie. The Out Point is the position in the media where
playback ends. if you set the Out Point of a movie to 5 minutes, when the movie reaches
the 5 minute mark, it stops playing (or loop back to the beginning, depending on which
When Finished option you have selected).
To set the In Point, move the playhead to a place you want the media to start playing
and click the first Set button. To set the Out Point, move the playhead to the place you
want the media to stop playing and click the second Set button. Clicking a Jump button
moves the playhead to the In Point or Out Point location.
When Finished Control
The When Finished drop-down menu enables you to control what happens when the
media finishes playing (when it reaches the Out Point).
You have three options:
• Loop The media loops back to the In Point.
• Hold The media stops and displays the last frame.
• Remove The media is removed from Live Broadcast. The remove function makes
the media transparent after it is done playing. For example, if you are doing a live
show with an intro video layered over your camera feed, when the intro video is fin-
ished it becomes transparent, leaving only the camera feed displayed.
Rewind
Play
Pause
Fast Forward
In point and Out Point times
Set buttons
Jump buttons