User`s guide

Using the Shot Editor
Shot Editor Playback
200
Wirecast User Guide | 104730
foreground is the same, then a Smooth transition is performed between the
foregrounds. However, no motion is performed. Or, if a logo is positioned in the top left
corner in an existing shot, and it is in the bottom right corner in a new shot, when you
make the new shot Live the logo smoothly transitions from the top left corner to the
bottom right corner. But the Build-In and Build-Out settings are ignored.
However, if you have two shots with a Foreground, but the media in each is different,
the Build-Out is performed for the existing shot, and the Built-In is performed for the
new shot.
Direction Menus These provide selections of where the Build-In comes from (top,
bottom, right, etc.) when it is added, and where the Build-Out goes when it is removed.
Fade In / Fade Out Checking these checkboxes causes an object to be added or
removed gradually. If unchecked, the object is instantly added or removed, much like a
cut transition.
Spin In / Spin Out Checking these checkboxes causes an object to be added or
removed in a spinning fashion.
Scale In / Scale Out Checking these checkboxes causes an object to be added or
removed in a scaled fashion.
Decelerate In / Accelerate Out Checking these checkboxes causes all of the above
actions to be performed at a slower or faster rate.
Apply To All Click this button to make the Motion Settings the same for all sources in a
shot. This is useful if you want to make all of your motion the same for all of the
elements in the shot.
Shot Editor Playback
The Playback Panel enables you to control how movies and music play in Wirecast. To
open the Playback Panel, click the Playback Panel button.
Check the Live Playback checkbox to cause your changes to be taken live in your
broadcast. The four control buttons enable you to rewind, play, pause, or fast forward.
In Point & Out Point sets the start and stop points in the media.
Playback Panel button