User`s guide

Using the Source Settings
IP Cameras
174
Wirecast User Guide | 104730
To enable the use of an IP camera and create a shot using it, you must first add it to
Wirecast. To do this select an IP camera from the Add Shot menu in the Main Shot List
window:
IP Cameras are usually auto-detected by Wirecast, but if not detected they can be
manually set up. To do this, select New IP Camera from the Sources menu in the Main
window. Then, in the Source Settings window, select an IP camera from the list of
devices, enter the IP Address of the camera, optionally check Use Audio, and click Apply:
Select an IP
Camera
Click Add Shot
menu
Click Apply
Check Add Audio
(optionally)
Enter the IP
Address
Select IP
Camera