User`s guide

Broadcasting
QuickTime Record To Disk
100
Wirecast User Guide | 104730
QuickTime Record To Disk
You can record your broadcast to disk at any time and you do not need to be
broadcasting. This means that you can use Wirecast as a way to create movies to post
on your Website. Record To Disk can be turned on or off, independent of your
broadcast.
To configure Record To Disk, select Broadcast > Broadcast Settings (or press Ctrl+Y),
then select Destination > Record To Disk. Click Browse to navigate to the file Wirecast
uses to save your broadcast to disk. If you check the Auto Increment checkbox, your
filename is appended with an incremental number. This enables you to start and stop
your broadcast repeatedly and save each movie segment in a uniquely named file. Click
Save to save your settings:
Note: When recording to disk, make sure it has sufficient write speed. In most cases a
7200 RPM (or faster) hard disk will yield the best results. USB2 external hard drives are
not a good choice for broadcast recording.
Note: When recording to disk using Quicktime with H.264 codec, Quicktime is used
for encoding, and higher quality options (such as B frames) will be disabled to
preserve compatibility.
Select Record
To Disk
Browse to target
file location
Check (optionally)
Auto Increment
File names
Save settings