Specifications

Specifications
Architect’s & Engineer’s Specifications
MediaMatrix • A division of Peavey Electronics Corporation • http://mediamatrix.peavey.com
Features and specifications subject to change without notice • Copyright © 2012 Peavey Electronics Corporation, All rights reserved • May-17-12• 80308008
xControl LCD
The controller shall provide control of functions in a project designed using NWare. The controller shall be designed for mounting in a standard NEMA 2-gang,
deep metal enclosure and shall include an unobtrusive light gray finish. The controller shall include two zone selector buttons, two source selector buttons,
two level selector buttons, one enter button and one mute button, all configurable as "virtual" encoders via software. An LCD screen that displays the available
configuration options shall be included. The base code of the controller shall be programmable via the front panel. The controller shall be powered via an
RJ-45 connector at the rear, which is connected to a NION via the EIA-485 port. The controller firmware shall be upgradable from software or from a direct
replacement of the firmware chip. The controller shall be the Peavey MediaMatrix® xControl LCD.
Front Panel
Buttons: Source, Level, Zone, Mute and Enter
capacitive selector buttons.
Screen: 60mm x 32mm (2.36" x 1.26") LCD color:
white on blue background, resolution: (128x64),
contrast ratio: (3:1).
Mechanical
NEMA 2-gang finish plate, requires 57.2mm
(2.25”) clearance depth minimum.
Mount in metal box coupled to EMT conduit.
NOTE: Take care to ensure that conduit coupling
hardware, wire or other terminating devices do
not obstruct the installation of the circuit assembly.
Power requirements & connection:
12VDC and EIA-485 data via RJ-45 connector.
30mA per unit. One NION can supply power to
up to 15 xControl LCDs.
NOTE: Use only unshielded, twisted pair cabling
for EIA-485 network (CAT5-CAT6E). Maximum
cable length for network circuit is 914m (3,000 ft.)
under optimal conditions.
NOTE: The xControl LCD is not an Ethernet
device and therefore cannot be powered using
PoE.
Daisy-chaining supported. Termination via
rear-panel switch.
NOTE: A maximum of 32 devices can be used on
a single EIA-485 network. This includes devices of
all types, i.e. xControl LCDs, NIONs, hubs, and
so on.
Finish:
Light gray plastic.
Net Weight:
0.155kg (0.34lbs).
Mechanical
xControl LCD
LEVEL
ZONE
SOURCE
ENTER
MUTE
4.6” (11.68cm)
4.6”
(11.68cm)
4.6” (11.68cm)
1.71”
(
4.34cm)
4.6” (11.68cm)
1.71”
(4.34cm)