Specifications

ManualsBrandsMassive Audio ManualsAutomotiveN3

Line Level Output Card Data Sheet

The NION NIO-8o Line Output Card is an 8 channel line level output device for use in NION DSP frames. Depending on the

NION model up to 4 NIO-8o cards may be loaded in a NION DSP.

• Eight Line Level Output audio channels

• 24 bit A/D

• 48 or 96 kHz audio sampling rate supported

• High reliability DIN Connector to backplane, using slide rail

for alignment

• Mini-Euro Connectors for easy output connection

Specifications

Features

Description

Architect’s & Engineer’s Specifications

The line level input processing card shall be an eight discrete channel device designed to enable line level analog outputs for the NION DSP audio processing

node. The slide rail support industrial package is designed to easily install in one of the slots provided on the rear of the NION DSP audio processing node. The

connection at the rear of the card shall use a DIN connector. Cards shall be available for mic and line level analog audio with options for digital and proprietary

audio transports. All cards types shall include separate software devices for integration into the configuration file. The line level output processing card shall be

the MediaMatrix NIO-8o or approved equal.

n i o n n i o - 8 o

AUDIO CHANNELS 8 Line-level signals only

FREQUENCY RESPONSE 20 ~ 20 kHz (+0.5/-0.6 dBr) Referenced @ 1 kHz. 22 dBu output level.

RELATIVE PHASE +/- 0.4 degrees 20 ~ 20 kHz, referenced @ 1 kHz. 22 dBu output level.

THD+N 0.004% 22 kHz bandwidth measurement, +4 dBu signal with 20 dB Headroom

DYNAMIC RANGE -110 dB A-weight filter measure

CROSSTALK -107 dB 20 ~ 20 kHz, measured between channel pairs (1-2, 3-4, 5-6, 7-8)

MAXIMUM INPUT SENSITIVITY SETTINGS NA

ANALOG GAIN NA

FULL-SCALE OUTPUT SETTINGS +24, +18, +12, +6 dBu Less than 1.0 dB error between settings

LINE INPUT IMPEDANCE NA

MIC INPUT IMPEDANCE NA

OUTPUT IMPEDANCE 100 ohms Balanced

MINIMUM LOAD IMPEDANCE 600 ohms Referenced to +22 dBu output

SAMPLE RATE 32 kHz – 96 kHz

Notes:

1. All specifications are typical for any channel(s).

2. All measurements are made with an AC line of 120 Volts rms / 60 Hz.

3. All measurements are made using 600-ohm balanced loads at 24 dBu full scale unless otherwise stated.

4. All measurements are made in the analog domain with gain/attenuation set for unity unless otherwise stated.

5. All measurements are made using 48 kHz sample rate.

MediaMatrix • A division of Peavey Electronics Corporation • http://mediamatrix.peavey.com