Specifications
Line Level Input Card Data Sheet
The NION NIO-8i Line Input Card is an 8 channel line level input device for use in NION DSP frames. Depending on the
NION model up to 4 NIO-8i cards may be loaded in a NION DSP.
• Eight Line Level Input audio channels
• 24 bit A/D
• 48 or 96 kHz audio sampling rate supported
• High reliability DIN Connector to backplane, using slide rail
for alignment
• Mini-Euro Connectors for easy input connection
Specifications
Features
Description
Architect’s & Engineer’s Specifications
AUDIO CHANNELS 8 Line-level signals only
FREQUENCY RESPONSE 20 ~ 20 kHz (+/-0.5 dBr) Referenced @ 1 kHz. 22 dBu output level.
RELATIVE PHASE +/- 0.4 degrees 20 ~ 20 kHz, referenced @ 1 kHz. 22 dBu output level.
THD+N 0.004% 22 kHz bandwidth measurement, +4 dBu signal with 20 dB Headroom
DYNAMIC RANGE -110 dB A-weight filter measure
CROSSTALK -102 dB 20 ~ 20 kHz, measured between channel pairs (1-2, 3-4, 5-6, 7-8)
MAXIMUM INPUT SENSITIVITY SETTINGS +30 to +3 dBu In 3db increments, less than 1.0 dB error between settings
ANALOG GAIN -3 TO +24dB True analog gain
FULL-SCALE OUTPUT SETTINGS NA
LINE INPUT IMPEDANCE 5.3K Ohms Effective for sensitivities of +33 dbu to +6 dbu
MIC INPUT IMPEDANCE NA
OUTPUT IMPEDANCE NA
MINIMUM LOAD IMPEDANCE NA
SAMPLE RATE 32 kHz – 96 kHz
Notes:
1. All specifications are typical for any channel(s).
2. All measurements are made with an AC line of 120 Volts rms / 60 Hz.
3. All measurements are made using 600-ohm balanced loads at 24 dBu full scale unless otherwise stated.
4. All measurements are made in the analog domain with gain/attenuation set for unity unless otherwise stated.
5. All measurements are made using 48 kHz sample rate.
The line level input processing card shall be an eight discrete channel device designed to enable line level analog inputs for the NION DSP audio processing
node. The slide rail support industrial package is designed to easily install in one of the slots provided on the rear of the NION DSP audio processing node. The
connection at the rear of the card shall use a DIN connector. Cards shall be available for mic and line level analog audio with options for digital and proprietary
audio transports. All cards types shall include separate software devices for integration into the configuration file. The line level input processing card shall be the
MediaMatrix NIO-8i or approved equal.
n i o n n i o - 8 i
MediaMatrix • A division of Peavey Electronics Corporation • http://mediamatrix.peavey.com
Features and specifications subject to change without notice • Copyright © 2007 Peavey Electronics Corporation, All rights reserved #80307393










