Specifications

Chapter 8: Layouts 75
Recalling Layouts
To recall a Layout:
1 Press Shift + Layout Mode on the Master Module. The Layout Recall screen appears and S6 enters Layout mode. (Or tap Recall
from either the Tracks or Layout Assign screen.)
2 In the Layout Recall grid, tap to recall the desired Layout. The surface updates to match the location and order of tracks in the
Layout. Unused strips remain empty.
3 Tap Done to close the Layout Recall grid.
Renaming, Rearranging, and Deleting Layouts in a Set
Once Layouts have been stored, they can be renamed, rearranged within the Layout grid, or deleted from the current Layout set.
To edit a Layout:
1 Go to the Tracks page and tap Layouts at the bottom of the screen (or press its corresponding switch).
2 Tap Edit (or press its corresponding switch).
3 Do any of the following:
• To rename a Layout, tap to select it in the grid, then double tap the
Layout Name shown at the bottom of the screen. Enter a
new name, and then tap
Done.
• To rearrange Layouts, drag any block to a new position. The block you tap or move is shown with an orange outline, while
the currently recalled Layout is outline in blue.
• To delete a Layout, drag it out of the grid and release it.
4 Tap Done to close the Layouts grid and return to the Layouts screen.
Saving and Loading Layout Sets
Layouts can be saved and loaded to/from disk. Use these features to load Layouts for specific sessions, to transfer Layouts to other
S6 systems, and for archiving. When saving or loading Layouts, all Layouts are saved as a set (you cannot save individual Layouts).
To save Layouts:
1 In the Layouts screen, tap Save.
2 In the dialog that appears, tap in the File Name field to bring up the touch keyboard and enter a name for the Layout set. Close
the touch keyboard by touching
Enter.
3 Tap Save. (Or tap Cancel to cancel the operation.)
To load Layouts:
1 In the Layouts screen, tap Load.
2 In the dialog that appears, tap to select the desired set of Layouts, then tap Open.
Figure 50. Layouts Recall grid