Specifications

Chapter 7: Plug-ins and Sends 69
Sends
Sends can be adjusted on the Master Module, Knob Module, and Process Module.
Adjusting Sends on the Master Module
To edit sends using the Master Module:
1 Attention a track with sends to the Attention Track Editor.
2 Press Sends in the Function Scroller. The first eight sends are assigned to the Attention Track Knobs.
3 Turn the knob to adjust the send level. In addition
• Press the knob
In switch to mute (or unmute) the send.
• Press the knob
Sel switch to toggle the send between pre- and post-fader.
• To adjust send pan, press the Level knob top.
L (and R, if the send is stereo) appear in the lower-right of the touchscreen.
4 To access additional sends, touch a bank of four sends in the Function Editor. Left and right brackets flash slowly around them.
5 To assign the four new sends to that side, touch or adjust an Attention Track Knob.
Adjusting Sends on the Knob Module
Sends can be edited using the Knob Module in default (per strip) or Expand mode.
Default Parameters are displayed four at a time (on strips with one Knob Module) or eight at a time (two Knob Modules).
Expand Mode Multiple parameters are “spilled” across one or more Knob Modules.
The following instructions explain default mode. For information on Expand mode (which supports all functions, not just plug-ins
and sends), see “Expand” on page 97.
To edit sends using the Knob Module:
1 Assign a track with sends to the surface.
2 Press Sends on that Process Module strip. The sends appear on the Knob Module knobs.
3 Turn a knob to adjust the level of the corresponding send. In addition
• Press the knob
In switch to mute (or unmute) the send.
• Press the knob
Sel switch to toggle the send between pre- and post-fader.
• To adjust send pan, press the knob top, then press lit
► ( Page > ) or ◄ (< Page) until R Pan and L Pan appear on the bottom
encoders of the Knob Module.
Sends switch on the Process Module