Specifications

Chapter 4: Master Module Screens 26
Function Editor
The Function Editor can display eight columns of eight parameters each. The four parameters in the top or bottom half of each col-
umn can be assigned to the left or right Attention Track Knobs.
Assigning New Parameters to the Attention Track Knobs
The left and right Attention Track Knobs can each control four parameters, which must be from the same function.
To assign a new bank of four parameters to the Attention Track Knobs:
1 Touch a function in the Function Scroller.
2 Touch a group of four parameters in the Function Editor.
Two brackets flash slowly around the selected parameters.
3 Before the brackets stop flashing, touch or turn any Attention Track Knob.
The four selected parameters are assigned to that side’s Attention Track Knobs, and the Function Editor provides the following
visual feedback:
• The parameter name, knob state, and value appear beside each Attention Track Knob.
• A left bracket (green in Figure 18) indicates the controls to its right are assigned to the left Attention Track Knobs.
• A right bracket (purple in Figure 18) indicates the controls to its left are assigned to the right Attention Track Knobs.
Figure 18. Function Editor
You can assign different function parameters to the left and right Attention Track Knobs (see “Locking the Knobs” on page 28).