Specifications

Chapter 3: First Time Setup 14
10 To confirm that the module flashing in the Surface page is connected and correctly positioned, touch or press any physical control
on that module.
Its lights turn off, and the next module flashes. If a module’s lights do not turn off, check your assignments in the
Settings > Surface
page. Touch Undo if you touch the wrong module.
11 When all modules are confirmed, touch Next.
Figure 4 shows all modules confirmed except the Knob Modules on the far right, which are light gray.
12 If you do not have Display Modules to assign, touch Done to accept the new arrangement and complete the process.
13 Drag each numbered Display Module icon to the frame diagram so it matches the number shown on the physical Display Module.
14 When you are done, touch Next.
Figure 4. Confirming modules
Figure 5. Assigning Display Modules