Specifications

Chapter 3: First Time Setup 11
Setting up S6 for the First Time
This section shows you how to do the following:
• Configure your S6 surface modules
• Connect S6 to your workstation(s)
• Enable EUCON connectivity in your audio application
Configuring the S6 Surface
After installing, rearranging, or removing modules you must configure your surface using the Master Module Settings > Surface
page.
To configure your S6 surface:
1 Press Home on the Master Module.
2 Touch Settings at the lower-right of the Home screen to display the Settings screen.
3 Touch Surface along the top of the Settings screen to open the Surface page.
4 Touch Config at the bottom-left of the Surface screen.
You must first assemble and connect your S6 system according to the procedures in the S6 Installation Guide. You must also install
important S6 System Software before configuring the surface. See “Starting Up the System for the First Time” on page 10.
Home switch on the Master Module
You can also press the Master Module Main Menu switch below Settings.
Top of Settings screen
Config, Next, Undo, Cancel, and Done appear at the bottom of the touchscreen during this process. The instructions refer to touch-
ing these controls but you can also press their Master Module Main Menu switches below them.
Main Menu switches
SwapHome
Layout
Mode
WS
All
App Type Flip
Mon B
Mon A
Tracks Monitoring Settings
C
ConfigSwapHome
Layout
Mode
Clear
WS
All
App Type Flip
Mon B
Mon A
Config