Specifications

Chapter 10: S6 Channel Modules 102

Knob Section

Each Knob Module strip has four knob sections, each with a dual-function, continuous knob, In and Sel switches, and an OLED. The

knob lights when active and, in certain contexts, it can also be pushed. The OLED shows the track name and number and the parameter

value.

In and Sel

Each knob section includes In and Sel switches.

In Toggles a parameter in and out, or between two values; it lights when active. The behavior depends on the audio application, and

not every parameter includes

In switch functionality.

Sel Toggles the knob function or a secondary parameter value. For example, Sel can toggle between Q and Frequency for an EQ

plug-in, or pre- and post-fader for a send.

Automation Indicators

The knob and In switch each have red and green LEDs that indicate automation status.

Knob Navigation Switches

At the bottom of the Knob Module are the navigation switches.

◄ ►

These switches navigate between groups of four function parameters. They light when available.

Back

Navigates up one level. It lights when available.

The

Config function (◄ and ► held down together) is not implemented.

OLED (1), knob (2), and In and Sel switches (3) for the knob

See “Setting the Track Automation Mode” on page 59.

Figure 62. ◄ (1), Back (2), and ► (3) navigation switches

See “Editing a Plug-in Using the Knob Module” on page 67.