Technical information

227
227
b. Hold the "Stop/Reset" button while pushing the power button. While still holding down the
power button, release the "Stop/Reset" button and then push it twice in a row.
c. Wait approximately 20 to 30 seconds until the LED shows 0.
d. Push the "Stop/Reset" button four (4) times in a row.
e. Push the power button twice.
f. Turn off the printer by pushing the power button one more time. The printer is now reset.
Next, reset the cartridge ink counter:
a. Unplug the power and the USB cables from the printer.
b. Open the cartridge door and hold down the power button.
c. Reconnect the power cables while still holding down the power button.
d. Close the cartridge door and release the power button. The ink cartridge is now reset.
- Your printer should respond as normal.
B. For Printer Model: Canon S9000, S300, S400, i550, i560, i850, i860, i865, i9100, i9950, PIXMA iP3000:
1. Turn off printer
2. Hold down Resume button and press Power button.
3. Keep holding down Power button and let Resume button go.
4. Press Resume button 2 times then let BOTH buttons go.
5. Green lights will flash and then stop blinking.
6. When green lights are solid, press the Resume button 4 times.
7. Press the Power button and the printer should turn off, if not, press the Power button once more.
- Your printer should respond as normal.
2. Pixma iP/MP/MX/MG Series: Waste Ink Counter Reset
a. With the printer powered off but still connected to a power source, press the Power button
while pressing and holding the Stop/ Reset button.
b. When the Power LED is lit, press the Stop/Reset button two (2) times while pressing and holding
the Power button.
c. When releasing the Power button and the Stop / Reset button (regardless of order), the printer
will move into a service mode (…waits for a menu selection)
d. When the LED lights green, press the Stop/Reset button the specified number of time(s)
according to the function listed in the table below (each time the Stop/Reset button is pressed, the LED
alternatively lights in orange and green, starting with orange)
- Your printer should respond as normal.
LED Function:
0 time Green - Power off
1 time Orange - Service pattern print
2 times Green - EEPROM print
3 times Orange - EEPROM reset
4 times Green - Waste ink counter reset
5 times Orange - Destination setting