Use and Care Manual

LH400ATV-2B OWNER’S/OPERATOR’S MANUAL 08.0

16. MAINTENANCE

16-19

4. Reinstall the fill plug. Tight securely (24.5 ft. lbs/35N.m).

5. Check for leaks.

WARNING

Operating your ATV with worn tires, improperly inflated tires, non-standard

tires or improperly installed tire will affect vehicle handling which could cause

an accident resulting in serious injury or death.

Follow the safeguards listed below to prevent this type of situation.

Important Safeguards

Maintain proper tire pressure according to charts below. Improper tire inflation

may affect ATV maneuverability.

Do not use improper tires. The use of non-standard size or type tires may

affect ATV handling.

Make certain the wheels are installed properly. If wheels are improperly

installed it could affect vehicle handling and tire wear.

Wheel Removal Procedure

1. Stop the engine, place the transmission in gear and lock the parking brake.

2. Loosen the wheel nuts slightly.

3. Elevate the side of the vehicle by placing a suitable stand under the footrest

frame.

4. Remove the wheel nuts and remove the wheel.

Tire Pressure

front

rear

See detail on the mark of sidewall

Wheel Installation

1. With the transmission in gear and the parking brake locked, place th wheel

in the correct position on the wheel hub. Be sure the valve stem is toward the

outside and totation arrows on the tire point toward forward rotation.

2. Attach the wheel nuts and finger

tighten them.