Use and Care Manual

LH400ATV-2B OWNER’S/OPERATOR’S MANUAL 08.0
16. MAINTENANCE
16-18
Rear Gearcase Lubrication
On independent suspension model
When the ATV on the a level surface, remove fill
plug and visually inspect the lubricant level
through the fill hole(1).Lubricant should be kept
even with the center of the drill point
approximately below the top of the fill hole.
NOTE: Do not add lubricant to the bottom of the
fill plug threads. The correct gearcase lubricant to use is SAE 80W/90 GL5
Weight Gear Lube.
Oil Changing Procedure
1. Remove drain plug (2). Catch and discard
used oil properly.
2. Clean and reinstall the drain plug with a new
sealing washer and tighten securely (14 ft.
lbs/20N.m).
3. Remove fill plug and add 10 ounces(300ml) of
SAE 80W/90 GL5. Weight Gear Lubricant and inspect oil level. Oil level
should be kept even with the center of the drill point (approximately below
the top of the fill hole).