Specifications

tecal portable dri-block
®
calibrators
11
Tecal 1200S High Temperature Portable
Calibration Furnace
Calibrate with Confidence with the NEW Tecal 1200S High Temperature Portable Calibration
Furnace. When precise temperature control is essential for optimum performance you can count
on Techne thermal solutions.
Key Features
● Very economically priced
● Wide temperature range
● Simple to use
● Multi-hole insert block for accurate comparison calibration
● Rapid heating rates
● Software available
● Rugged case with carry handle
The Tecal 1200S Block calibrator utilises a special heater design for optimum temperature
uniformity and rapid heating rates. The isothermal block assembly is machined from a special
alloy giving excellent thermal conductivity which also resists high-temperature oxidation. This
block is designed to optimize performance between sufficient mass for good stability/
uniformity but a low enough mass to achieve rapid heating/cooling rates and stabilization
periods. The standard fixed block has 4 extra deep immersion test holes accepting Ø8mm probes
x 80 mm deep for use with a reference probe typically an R or S type thermocouple or an SPRT.
Technical Specification
Minimum temperature 150°C
Maximum temperature 1200°C
Display accuracy ±3°C
Temperature uniformity ±0.2°C
Temperature stability ±0.2°C (at 1200°C after 20 mins)
Display resolution 0.1°to 999.9 then 1°to 1200°C Selectable °C or °F
Heating rate, 100°C to 1200°C 20 minutes
Cooling rate, 1200°C to 200° 140 minutes
Large insert size Ø34mm x 155 mm with 4 off bores Ø8mm x 80 depth
Fan cooling Automatic
Dimensions H x W x D 350 x 200 x 300mm
Weight 10kg
Ordering Information
FDB1200XS Tecal 1200 S 230v with RS-232
FDB1200XP Tecal 1200 S 120v with RS-232
Accessories
FCAL1200 Hard Carry case 1200S
Insert blocks Ø34 x 155mm long
FINS1200A Insert Block probe 4x Ø8.0mm (Standard insert)
FINS1200B Insert Block probe 2xØ3mm,2xØ4mm,2xØ6mm
FINS1200C Insert Block probe Ø1/8”,Ø1/4”, Ø3/16”, Ø5/16”, Ø3/8”
FINS1200D Insert Block probe 2xØ3/16”,2xØ1/4”, 2xØ3/8”
FINS1200E Insert Block probe 6x Ø1/4”
Ceramic Top insulator
FCER1200A Insulator A for block 4 x Ø8.0mm (Standard insert)
Included with the unit
FCER1200B Insulator B for block 2 x Ø3mm, 2 x Ø4mm, 2 x Ø6mm
FCER1200C Insulator C for block Ø1/8”, Ø1/4”, Ø3/16”, Ø5/16”, Ø3/8”
FCER1200D Insulator D for block 2 x Ø3/16”,2 x Ø1/4”, 2 x Ø3/8”
FCER1200E Insulator E for block 6 x Ø1/4”
FCAL1200 Hard carry case 1200S
FCERT1200 UKAS cal cert at 150, 420, 660, 960, 1200ºC
1200S