Installation Guide

10
HANGING
THE DOOR
Place the assembled door onto the secured track and
tighten each anti-jump block. Ensure all parts are
operating correctly by sliding the door side-to-side.
11
FLOOR-MOUNTED DOOR
GUIDE INSTALLATION
Once the door is plumb, position the floor-mounted
door guide inside the mortised door, line up close to
the opening. Slide the door side-to-side to ensure
functionality for final placement then mark holes with
a pencil and pre drill 1/4" holes. If drilling directly into
a concrete floor, use the provided anchors.
12
OPTIONAL WALL-MOUNTED
DOOR GUIDE INSTALLATION
Line up close to the opening, position and secure the
wall-mounted door guide directly into the wall or trim,
extending the guide as necessary to allow the door to
travel side-to-side. Tighten to secure in place
Note: Adjust correctly for 1-3/8" or 1-3/4" thick doors
for smooth opening and closing operation.
1/4" (8 mm)
Drill depth
1 3/16"
(30 mm)
Drill depth
1 3/16"
(30 mm)
1/8" (3 1/2 mm)
1/4" (8 mm)
Drill depth
1 3/16"
(30 mm)
Drill depth
1 3/16"
(30 mm)
1/8" (3 1/2 mm)
1/4" (8 mm)
Drill depth
1 3/16"
(30 mm)
Drill depth
1 3/16"
(30 mm)
1/8" (3 1/2 mm)
Barn Door Installation Guide
BARN DOOR HARDWARE STRAIGHT STRAP KIT
©2017 Masonite International Corporation. MIC-171901 1-800-663-DOOR masonite.com