User's Manual

Radius-7 Chapter 7- Specifications
www.masimo.com 75 Masimo
Guidance and Manufacturer's Declaration- Electromagnetic
Emissions
Guidance and Manufacturer's Declarations - Electromagnetic Emissions
The ME Equipment is intended for use in the electromagnetic environment specified below. The customer
or the user of the ME Equipment should assure that it is used in such an environment.
Emission
Test
Compliance Electromagnetic Environment - Guidance
RF
Emissions
CISPR 11
Group 1
ME Equipment uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
RF
Emissions
CISPR 11
Class B Suitable for use in all establishments, including domestic environments.
Guidance and Manufacturer's Declaration- Electromagnetic
Immunity
Guidance and Manufacturer's Declaration - Electromagnetic Immunity
The ME Equipment is intended for use in the electromagnetic environment specified below. The
customer or the user of the ME Equipment should assure that it is used in such an environment.
Immunity Test IEC
60601
Test Level
Compliance
Level
Electromagnetic Environment - Guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2
+6 kV
contact
+8 kV air
+6 kV
contact
+8 kV air
Floors should be wood, concrete or ceramic tile. If
floors are covered with synthetic material, the relative
humidity should be at least 30%.
Power frequency
(50 / 60 Hz)
magnetic field.
IEC 61000-4-8
3 A/m 3 A/m Power frequency magnetic fields should be at levels
characteristic of typical location in a typical hospital
environment.
Radiated RF
IEC 61000-4-3
3 V/m
80 MHz
to 2.5
GHz
3 V/m Portable and mobile RF communications equipment
should be used no closer to any part of the ME
Equipment, including cables, than the recommended
separation distance calculated from the equation
applicable to the frequency of the transmitter.
Recommended separation distance