Service manual

Radical Signal Extraction Pulse Oximeter Service Manual
UM10029–0406
ii
Table of Contents
Page
1. Overview ....................................................................................1-1
1.1. About this Manual ....................................................................1-1
1.2. Warnings, Cautions and Notes ................................................1-1
2. Maintenance...............................................................................2-1
2.1. Introduction ..............................................................................2-1
2.2. Cleaning...................................................................................2-1
3. Battery Operation and Maintenance........................................3-1
3.1. Overview ..................................................................................3-1
3.2. Replacing the Battery ..............................................................3-1
4. Performance verification ..........................................................4-2
4.1. Power-On Self-Test .................................................................4-2
4.2. Key Press Button Test .............................................................4-2
4.3. Alarm Limit Test.......................................................................4-2
4.4. LED Brightness................................ Erreur ! Signet non défini.
4.5. Testing the Rad-8 with Masimo SET Tester (Optional)...........4-5
5. Repair .........................................................................................5-6
5.1. Safety Precautions:..................................................................5-6
5.2. General Procedures.................................................................5-6
5.3. Troubleshooting .......................................................................5-6
5.4. Service Messages: ..................................................................5-8
5.5. Repair Policy............................................................................5-9
5.6. Return Procedure ....................................................................5-9
6. Drawings and Schematics........................................................6-3