Operator's Manual
Table Of Contents
- About this Manual
- Product Description
- Indications for Use
- Contraindications
- Warnings and Cautions
- Chapter 1: Technology Overview
- Signal Extraction Technology (SET)
- rainbow Pulse CO-Oximetry Technology®
- Pulse CO-Oximetry vs. Drawn Whole Blood Measurements
- General Description for Total Hemoglobin (SpHb)
- General Description for Total Arterial Oxygen Content (CaO2)
- General Description for Carboxyhemoglobin (SpCO)
- General Description for Methemoglobin (SpMet)
- General Description for Oxygen Reserve Index (ORI)
- SpCO, SpMet, and SpHb Measurements During Patient Motion
- rainbow Acoustic Monitoring (RAM) Technology
- Chapter 2: Radical-7 Descriptions
- Chapter 3: Setup
- Chapter 4: Operation
- Using the Touchscreen and Buttons
- Using Screen Lock
- Using the Home Button
- Standby and Power Off
- Navigating the Radical-7
- About the Display View
- Sensitivity Modes Overview
- Changing Sensitivity Modes
- Accessing the Main Menu
- Navigating the Main Menu
- Parameter Settings
- Chapter 5: Profiles
- Chapter 6: Alarms and Messages
- About Alarms
- Silencing the Alarms
- Adaptive Threshold alarm (ATA) Feature
- 3D Alarms
- Messages
- Replace Sensor Message
- Replace Cable Message
- Replace Adhesive Sensor Message
- Incompatible Sensor Message
- Incompatible Adhesive Sensor Message
- No Adhesive Sensor Connected Message
- Interference Detected Message
- SpO2 Only Mode Message
- RAM Check Sensor Message
- RAM Sensor Initializing Message
- Low Battery Message
- Low Perfusion Index Message
- Low Signal IQ Message
- Low SpCO SIQ Message
- Low SpMet SIQ Message
- Low SpHb SIQ Message
- Speaker Failure Message
- Invalid Parameter Alarm Message
- No Cable Connected Message
- No Sensor Connected Message
- Pulse Search Message
- Sensor Initializing Message
- Sensor Off Patient Message
- Incompatible Cable Message
- Near Expiration Message
- Chapter 7: Troubleshooting
- Chapter 8: Specifications
- Chapter 9: Service and Maintenance
- Appendix
- Index
Radical-7 Warnings and Cautions
www.masimo.com 24 Masimo
Note: It is recommended that Radical-7 battery is fully charged prior to
use.
Note: Always charge Radical-7 when it is not in use to ensure that the
Radical-7 battery remains fully charged.
Note: All batteries lose capacity with age, thus the amount of run time at
Low Battery will vary depending upon the age of the battery.
Note: Do not loop the patient cabling into a tight coil or wrap around
the device, as this can damage the patient cabling.
Note: Additional information specific to the Masimo sensors compatible
with Radical-7, including information about parameter/measurement
performance during motion and low perfusion, may be found in the
sensor's directions for use (DFU).
Note: When using the Maximum Sensitivity setting, performance of the
"Sensor Off" detection may be compromised. If the Radical-7 is in this
setting and the sensor becomes dislodged from the patient, the potential
for false readings may occur due to environmental "noise" such as light,
vibration, and excessive air movement.
Note: The 3D Desat Index™ alarm is intended as an adjunct alarm rather
than in place of the Low SpO2 alarm.
Note: When monitoring acoustic respiration, Masimo recommends
minimally monitoring both oxygenation (SpO2) and respiration (RRa).
Note: High-intensity extreme lights (such as pulsating strobe lights)
directed on the sensor, may not allow the pulse CO-Oximeter® to obtain
vital sign readings.
Warning: Plethysmographic waveforms displayed on multi-parameter
monitors using SatShare should only be used for reference. Only