Operator's Manual
Table Of Contents
- About this Manual
- Product Description
- Indications for Use
- Contraindications
- Warnings and Cautions
- Chapter 1: Technology Overview
- Signal Extraction Technology (SET)
- rainbow Pulse CO-Oximetry Technology®
- Pulse CO-Oximetry vs. Drawn Whole Blood Measurements
- General Description for Total Hemoglobin (SpHb)
- General Description for Total Arterial Oxygen Content (CaO2)
- General Description for Carboxyhemoglobin (SpCO)
- General Description for Methemoglobin (SpMet)
- General Description for Oxygen Reserve Index (ORI)
- SpCO, SpMet, and SpHb Measurements During Patient Motion
- rainbow Acoustic Monitoring (RAM) Technology
- Chapter 2: Radical-7 Descriptions
- Chapter 3: Setup
- Chapter 4: Operation
- Using the Touchscreen and Buttons
- Using Screen Lock
- Using the Home Button
- Standby and Power Off
- Navigating the Radical-7
- About the Display View
- Sensitivity Modes Overview
- Changing Sensitivity Modes
- Accessing the Main Menu
- Navigating the Main Menu
- Parameter Settings
- Chapter 5: Profiles
- Chapter 6: Alarms and Messages
- About Alarms
- Silencing the Alarms
- Adaptive Threshold alarm (ATA) Feature
- 3D Alarms
- Messages
- Replace Sensor Message
- Replace Cable Message
- Replace Adhesive Sensor Message
- Incompatible Sensor Message
- Incompatible Adhesive Sensor Message
- No Adhesive Sensor Connected Message
- Interference Detected Message
- SpO2 Only Mode Message
- RAM Check Sensor Message
- RAM Sensor Initializing Message
- Low Battery Message
- Low Perfusion Index Message
- Low Signal IQ Message
- Low SpCO SIQ Message
- Low SpMet SIQ Message
- Low SpHb SIQ Message
- Speaker Failure Message
- Invalid Parameter Alarm Message
- No Cable Connected Message
- No Sensor Connected Message
- Pulse Search Message
- Sensor Initializing Message
- Sensor Off Patient Message
- Incompatible Cable Message
- Near Expiration Message
- Chapter 7: Troubleshooting
- Chapter 8: Specifications
- Chapter 9: Service and Maintenance
- Appendix
- Index
Radical-7 Chapter 9: Service and Maintenance
www.masimo.com 199 Masimo
• Memory effects of the battery may shorten run-time. When
battery run time is significantly reduced, it is advisable to
completely discharge and fully recharge the battery.
Charging can occur while the Handheld is docked and
turned on, the most efficient charge times are achieved
when the Handheld is turned off.
During battery operation of the Radical-7, note that the following
operating conditions affect the estimated run time of the included
rechargeable batteries:
Estimated Run Times of Battery Power
The following tables outline the estimated run times of the battery-
powered Radical-7. The time estimates are based on a Radical-7 with fully
charged batteries. The time estimates are also based on a Radical-7 with
and without the back-light illuminated.
The Radical-7 is always configured to include the Handheld battery. It
may optionally be configured to include the Docking Station battery.
Determine the configuration of the system before referencing the
following tables.
Run Time for Handheld Only
In this configuration, the Radical-7 is configured to only include the
Handheld battery (standard configuration). When running on battery
power, it is advisable to operate only the Handheld. On battery power, it
is possible to operate the Standalone (Handheld attached to the Docking
Station with the Handheld battery providing power to the Docking