Operator's Manual
Table Of Contents
- About this Manual
- Product Description
- Indications for Use
- Contraindications
- Warnings and Cautions
- Chapter 1: Technology Overview
- Signal Extraction Technology (SET)
- rainbow Pulse CO-Oximetry Technology®
- Pulse CO-Oximetry vs. Drawn Whole Blood Measurements
- General Description for Total Hemoglobin (SpHb)
- General Description for Total Arterial Oxygen Content (CaO2)
- General Description for Carboxyhemoglobin (SpCO)
- General Description for Methemoglobin (SpMet)
- General Description for Oxygen Reserve Index (ORI)
- SpCO, SpMet, and SpHb Measurements During Patient Motion
- rainbow Acoustic Monitoring (RAM) Technology
- Chapter 2: Radical-7 Descriptions
- Chapter 3: Setup
- Chapter 4: Operation
- Using the Touchscreen and Buttons
- Using Screen Lock
- Using the Home Button
- Standby and Power Off
- Navigating the Radical-7
- About the Display View
- Sensitivity Modes Overview
- Changing Sensitivity Modes
- Accessing the Main Menu
- Navigating the Main Menu
- Parameter Settings
- Chapter 5: Profiles
- Chapter 6: Alarms and Messages
- About Alarms
- Silencing the Alarms
- Adaptive Threshold alarm (ATA) Feature
- 3D Alarms
- Messages
- Replace Sensor Message
- Replace Cable Message
- Replace Adhesive Sensor Message
- Incompatible Sensor Message
- Incompatible Adhesive Sensor Message
- No Adhesive Sensor Connected Message
- Interference Detected Message
- SpO2 Only Mode Message
- RAM Check Sensor Message
- RAM Sensor Initializing Message
- Low Battery Message
- Low Perfusion Index Message
- Low Signal IQ Message
- Low SpCO SIQ Message
- Low SpMet SIQ Message
- Low SpHb SIQ Message
- Speaker Failure Message
- Invalid Parameter Alarm Message
- No Cable Connected Message
- No Sensor Connected Message
- Pulse Search Message
- Sensor Initializing Message
- Sensor Off Patient Message
- Incompatible Cable Message
- Near Expiration Message
- Chapter 7: Troubleshooting
- Chapter 8: Specifications
- Chapter 9: Service and Maintenance
- Appendix
- Index
Radical-7 Chapter 8: Specifications
www.masimo.com 187 Masimo
Wireless Radio (If Installed)
Duty Cycle 6% (maximum)
(Note: The software sends 120 bytes at 62.5 Hz for 7,500 bytes
per second, or 60 Kbps. Worst duty cycle will be at the
minimum transmission bit rate of 1.1 Mbps. Therefore, the
calculated duty cycle is 0.06 Mbps / 1.1 Mbps, which results in
a duty cycle of approximately 6%.)
Compliance
USA FCC ID: VKF-RAD7CA or VKF-RAD7A or VKF-RAD7B.
FCC parts 15.207, 15.209, 15.247, and 15.407
Canada IC ID: 7362A-RAD7CA or 7362A-RAD7A or 7362A-
RAD7B
RSS-247
Europe
EU Radio Equipment Directive (RED 2014/53/EU):
EN 300 328 V2.1.1:2016
EN 301 893 V2.1.1:2017
EN 301 489-17 V3.1.1:2012
EN 62311:2000
Output Interface
SatShare (RDS-1). See
Serial Interface Specifications
on page 186.