Operator's Manual

Rad-97 Chapter 3: Setting Up
www.masimo.com 44 Masimo
Powering the Rad-97 ON and OFF
To Power ON Rad-97
1. Press and hold the Home Button for more than two (2) seconds, until one (1)
audible tone sounds.
2. The Home Button will illuminate Green and the Rad-97 will power on.
To Power OFF Rad-97
When powering off the Rad-97, the device remembers the last settings if the Power on Profile
is set to Previous Profile. See Access Control on page 107. The device also remembers the
Device Mode when turned off, and will turn back on in that mode.
1. Press and hold the Home Button for more than 8 seconds, until two (2) audible
tones sound.
2. The Home Button will flash Orange.
3. The Rad-97 will power down and turn off.
Initial Battery Charging
Before use, the Rad-97 battery must be charged completely.
To charge Rad-97
1. Plug the AC power cord into the power entry module. Make sure it is securely
plugged in.
2. Plug the AC power cord into an AC power source.
3. Verify that the battery is charging: