Operator's Manual

Rad-97 Chapter 15: Specifications
www.masimo.com 194 Masimo
Guidance and Manufacturer's Declaration-Electromagnetic
Immunity
Guidance and Manufacturer's Declaration - Electromagnetic Immunity
The ME Equipment is intended for use in the electromagnetic environment specified below.
The customer or the user of the ME Equipment should assure that it is used in such an
environment.
Immunity Test IEC 60601
Test Level
Compliance
Level
Electromagnetic Environment -
Guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2
+6 kV
contact
+8 kV air
+6 kV contact
+8 kV air
Floors should be wood, concrete, or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
Electrical fast
transient/ burst
IEC 61000-4-4
+/- 2 kV for
power lines
+/- 1 kV for
input/
output
lines
+/- 2 kV for
power lines
+/- 1 kV for
input/ output
lines
Mains power quality should be that
of a typical commercial or hospital
environment.
Surge
IEC 61000-4-5
+/-1 kV
line(s) to
line(s)
+/- 2 kV
line(s) to
earth
+/-1 kV line(s)
to line(s)
+/- 2 kV line(s)
to earth
Mains power quality should be that
of a typical commercial or hospital
environment.
Voltage dips, short
interruptions, and
voltage variations on
power supply input
lines
IEC 61000-4-11
100% dip
in mains
voltage for
0.5 cycle
60% dip in
mains
voltage for
5 cycle
30% dip in
mains
voltage for
25 cycle
100% dip in
mains voltage
for 0.5 cycle
60% dip in
mains voltage
for 5 cycle
30% dip in
mains voltage
for 25 cycle
Mains power quality should be that
of a typical commercial or hospital
environment.