Operator's Manual

Root Chapter 5: Electronic Medical Record (EMR) Push
www.masimo.com 125 Masimo
Sending Patient Data to the EMR
Follow the instructions below to send patient data to a data management
system using the EMR Push feature.
Note: Parameters that appear on the EMR Push screen can be
pre-configured on Patient SafetyNet. For questions about pre-configuring
EMR Push parameters, see Masimo Technical Services on page 178.
1. Select the EMR Push icon at the bottom of the Root Main
Screen.
2. In the Authentication screen, enter a username and PIN.
3. Press OK.
Note: Username and PIN requirements are enabled through
Patient SafetyNet. If unable to authenticate a username and PIN,
see Masimo Technical Services on page 178.
4. In the EMR Push screen, review and manually enter patient data
before submitting to the EMR. See Manually Entering Patient
Data on page 123.
5. Press the Submit button to send patient data to the EMR or press
the Back button to return to the Main Screen.
6. After pressing the Submit button, select to send
patient data to the EMR.