Troubleshooting guide

CHAPTER 1
INTRODUCTION
ASSUMPTIONS
The following four assumptions are made to simplify the documentation.
1. All texts pertain only to GSA approved containers.
2. Mounting position of lock
All text reference to the X-07 in this document is with the X-07 mounted in the BOLT
DOWN position.
3. Thermal relock
Unless otherwise noted, this document assumes that the thermal relock is working correctly.
After one (1) full year in service, no thermal relock problems have been found in the failure
analysis of returned locks.
4. Magnetic relock
Unless otherwise noted, this document assumes that the magnetic relock is working cor-
rectly. After one (1) full year in service, no magnetic relock problems have been found in the
failure analysis of returned locks.
CHECKOUT STANDARDS
Check out of the X-07 lock is started from a power off condition. To insure a power off condi-
tion, you must wait at least 90 seconds after you have stopped dialing. The display will go blank
40 seconds after dialing has stopped and sometimes is misinterpreted as a power off state.
Call Mas-Hamilton Technical Support for further assistance at 800-950-4744 or 859-253-4744.