Troubleshooting guide

After executing the combination and with “OP” displayed, the X-07 dial is restricted when

turned to the right. When the dial is turned back to the left and “OP” goes out, the dial is free

turning.

First, a bit of information about the containers and the locking bars. The bars are two equal

lengths of hardened steel that extend out of the container drawer head and into the side walls of

the container. When extended, the locking bars prevent any movement of the drawer head.

When retracted, these bars are clear of the container walls and allow the container drawer to be

pulled out of the container.

When the locking bars are extended, the container locking mechanism is designed to leave a

space between the locking bars that is sufficient for the X-07 bolt to extend into, yet small

enough to restrict the travel of the locking bars when the container is closed and the X-07 bolt is

extended between them.

1. X-07 bolt may be binding or jamming as it is retracted from the gap between locking bars.

2. After executing the combination and with “OP” displayed, turn the dial slowly to the right

while feeling and listening for the slide mechanism to engage.

3. If you feel the mechanism has engaged, do the following:

a. Slightly force the dial to the right adding force as you attempt to open. Hold pressure on

the container handle toward the closing direction or “jiggle” the handle.

b. Open drawer and remove dust cover and check the gap between the container locking

bars for sufficient space to accommodate the X-07 bolt.

c. Inspect bolt on the X-07 for gouges and scratches from scraping on bars.

d. Make adjustment (usually by grinding or filing locking bars) and replace parts as re-

quired.

DIAL RESTRICTED WHEN CLOSED/TURNS FREELY WHEN CON-

TAINER OPEN