Troubleshooting guide

6. Loosen the two screws INSIDE the dial ring, being careful not to damage the flex
cables.
These screws are in slotted holes to allow centering of LCD display and dial assembly.
Once loosened you should be able to turn the dial ring slightly to the left and right on the
container.
7. Reinstall the dial assembly, drive cam, and cam screw. Tighten the cam screw.
8. Move dial ring around until dial assembly turns freely.
9. Remove cam screw, drive cam, and dial assembly, tighten the inside dial ring screws.
10. Replace the dial ring cover dial assembly, drive cam and screw, and back cover assembly.
11. Check out lock for any problems.
BENT SPINDLE
1. Execute combination and open container.
2. Pull out the drawer, release the interlock and extend the locking bars into the locked position.
Turn the X-07 dial to extend the bolt into the locked position.
3. Follow instructions for Appendix B.
4. Inspect spindle on dial assembly.
5. If bent, then replace spindle and dial assembly.
GENERATOR GEARS BINDING
1. Follow instructions in Appendix A.
2. Inspect generator gear teeth (3 gears on back cover electronic card) for damage. If dam-
aged, replace all three gears.
3. Gear teeth binding from foreign substance. Remove foreign substance.
MOTOR GEAR INSTALLED 180 DEGREES OUT OF SYNC.
1. This can happen if the motor was installed without fully extending the lock bolt.
2. Remove the motor and follow instructions in Appendix G.
DIAL RESTRICTED TO THE RIGHT AFTER “OP”