Troubleshooting guide

f. As the slide moves down, it will allow the lever assembly to move into the proper posi-
tion to be engaged by the drive cam.
g. The lever assembly is attached to the bolt mechanism and when moved in the direction
away from the bolt by the drive cam, it will retract the bolt.
h. Continuing to turn the dial in the clockwise direction will move the lever assembly and
bolt to their full limit of travel (viewed from front of dial).
i. The dial can only be turned in the clockwise direction until the bolt is fully retracted.
j. With the bolt fully retracted, the X-07 lock is open.
8. To lock the X-07, the container locking bars must have been moved to the locked or ex-
tended position and then the dial must be turned in the counterclockwise direction (when
viewed from the front of dial) until the X-07 bolt is fully extended. As the dial is turned in the
CCW direction, the following sequence of events will occur to lock the container.
a. The drive cam gear teeth will turn the stepper motor gear CW to its home position
(viewed from the front of the dial.)
b. As the stepper motor is being reset, the slide cam will also be rotated back to its home
position.
c. As the slide cam rotates, it will move the slide up to its home position.
d. The slide will lift the lever assembly, disengaging it from the drive cam, freeing the lever
assembly to extend the bolt to the locked position.
e. When the lever reaches its home position, resting against the slide assembly stop, the
bolt will be fully extended between the container locking bars.
f. The dial is now free turning, and the X-07 is scrambled (locked position).
g. The correct combination must be executed to open the lock again.