Operating instructions

11
(2) The display will flash the new combination three times and then display the
symbol PO (for Pull Out Change Key) (photo 1). Remove the Change Key
(photo 2). This will cause the Change Key symbol to disappear. The display will
show the symbol CC (Confirm Combination(s)) (photo 3).
(3) To confirm the combination(s), redial the new combinations. When the symbol
OP (OPen right) appears on the display, continue dialing to the right to retract
the bolt. The combination is now set.
7b. If selection 2 or 3; Dual or Super/Sub Mode was chosen:
In Dual Combination Mode: Either of the two combinations can be entered
first.
In Supervisory/Subordinate Mode: Supervisory combination must be en-
tered first.
(1) The E1 symbol (enter first combination) will be displayed (photo 1). Enter
the new first combination: (Example 30-60-90)
Dial:
Left to the first number. Stop. (photo 2)
Right to the second number. Stop. (photo 3)
Left to the third number. Stop. (photo 4)
Right until display flashes new combination. (photo 5)