Operating instructions

5
Note: When dialing to the right after the E1, E2, or E3 prompts, the first
numbers to appear on the LCD will alternately be 00 or 50. DO NOT stop on
these numbers the first time they appear if they are part of your three number
combination. Continue to dial to the right until the number appears for the
second time.
If at any time the dial remains stationary for more than 10 seconds, the computer will
reset (LCD will go blank) requiring the operator to redial the entire combination.
Caution: An X-08 lock will register a Surreptitious Entry Attempt (SA) error
condition when fifteen unsuccessful attempts to open the lock are made. The
condition must be reset before the lock will operate normally. See the section
on “Surreptitious Attempt”.
If You Pass Your Target Number When Dialing:
Example A: Target Number = 25.
If you pass your target number by 10 or more, to 35 or greater, continue dialing
until you reach the target number again.
Example B: Target Number = 25.
If you pass the target number by no more than 9 numbers, to 34 or less, you may
dial to the left and the display will “jump back” about 10 numbers. Now you may
dial slowly to the right to the target number.
If You Dial the Wrong Number:
Example A: When dialing, you pause on the wrong number for E1 or E2. E2 or E3
then appears on the display. Dialing left returns the display to E1 or E2 to allow
redialing of that number in the combination sequence.
Example B: When dialing, you pause on the wrong number for E3. A lightning bolt
is displayed to indicate an incorrect combination. Dial left before the lightning
bolt disappears to return the display to E3 and allow the third number in the
combination to be redialed.
Redial Entire Combination If:
A. The screen goes blank before the lock bolt is retracted.
B. After backing up and redialing a correct number, a lightning bolt is displayed.