Operating instructions

4
DIALING THE X-08/CEX-08
DIALING METHODS
The user should dial with complete full wrist turns. Stopping to regrip produces pauses in
dialing activity. This helps the X-08 distinguish between human and robotic dialers.
The X-08 may mistake a human for a robot if the user dials more than 1.3 revolutions in
the ClockWise (CW) direction with no pauses in dialing activity.
Important: The X-08 has protective software that detects robotic dialing. If
robotic dialing is detected, the X-08 will not open even if the correct
combination has been dialed.
TO POWER THE LOCK
You will always dial to the left (CounterClockWise) to “power” the lock. It usually
requires 4-6 turns of the dial to generate sufficient power for lock operations. The lock is
considered to be “powered” as soon as something appears on the display.
When you dial left to power the lock , it will first display any error conditions that exist
on the lock (SA, CE , or SC). Also, if the number of consecutive unsuccessful attempts is
three or more, this count will be displayed once you stop dialing. The count will disap-
pear when you dial right to resume operations.
Caution: If you continue to dial left once the lock is powered, the successful
openings count will appear. You should not dial this far unless you are
specifically instructed to do so during an operational procedure. The necessary
operating procedure may vary from the normal operating instructions if you
dial this far, depending on the current condition of the lock.
Note: If a left arrow and dL (dial Left) appear at
any time during dialing, you need more power to
complete your operation. Dial left to generate power
until the lock displays a right arrow and the previously
displayed numbers or symbol(s).
DIALING A COMBINATION
When dialing a combination, you will be prompted with E1,
E2 and E3 for the first, second, and third numbers of the
combination, respectively. Once the prompt for a number ap-
pears, dial to the right to select the appropriate number.