Operating instructions

15
SURREPTITIOUS ATTEMPT
SA indicates that a Surreptitious Entry Attempt condition exists. An X-08 lock will
register a Surreptitious Entry Attempt condition when fifteen unsuccessful attempts to
open the lock are made. The condition must be reset using the Reset Combination before
the lock will open and operate normally.
RESET SA CONDITION
Note: If in Supervisory/Subordinate mode, you must first dial the valid
supervisor combination as required to set the lock to LU mode before attempting
the Reset SA procedure. See “To Lock Up in Supervisory/Subordinate Mode”.
If SA is displayed, then you will need to reset the Surreptitious Attempt using the follow-
ing steps.
Note: The factory default for the Reset Combination is 50-25-50.
1. Dial continuously to the left (CCW) until the number of successful openings is
displayed.
2. After the successful openings counter starts displaying, stop dialing. The display
will change to show the unsuccessful attempts counter along with a lightning bolt
and a right arrow.
3. Dial right to 99. E1 will appear.
4. Dial the Reset Combination as if dialing the combination to open the lock. A
lightning bolt will appear.
5. While the lightning bolt is displayed (indicating power is still up), dial left until
SA appears.
6. Dial the correct opening combination(s) for the lock, whether it be one combination
for single combination mode, two combinations for dual combination mode, or the
supervisory combination (to put lock in UL mode) followed by the subordinate
combination for Supervisory/Subordinate mode. The lightning bolt will continue
to be displayed during this time.
The Surreptitious Attempt condition should now be reset.
Note: Resetting the SA condition will not zero the unsuccessful attempts
count. You must successfully open the lock before the count will be reset to 0.