Operating instructions

12
SUPERVISORY/SUBORDINATE MODE
In this mode, two combinations must be correctly dialed to
open the lock. However, it is different from Dual Mode be-
cause the Supervisory Combination must only be dialed once
to UnLock (UL) the lock. Once the Supervisory Combination
has been entered, the Subordinate Combination can be used
to open the lock at any time during this “unlocked” state.
Whenever the Supervisory Combination is redialed, the lock will display LU (Locked
Up) , and the Subordinate Combination will no longer open the lock.
To UnLock (UL)
Supervisory Operator:
1. Dial left until lock is “powered”.
2. Dial right to dial the Supervisory Combination as if dialing the combination to
open the lock. EXAMPLE: Combination = 25-50-75
E1 will be displayed.
Dial right to first number, 25. Stop. E2 will appear.
Dial right to second number, 50. Stop. E3 will appear.
Dial right to third number, 75. Stop.
UL (UnLocked) is displayed indicating that the Subordinate Operator can now
open the lock using only the Subordinate Combination. The X-08 will now operate
as if it were in a single combination mode.
To Open the Lock
Subordinate Operator:
1. Dial left until lock is “powered”.
2. Dial right to dial the Subordinate Combination.
EXAMPLE: Combination = 30-60-90
E1 will be displayed.
Dial right to first number, 30. Stop. E2 will appear.
Dial right to second number, 60. Stop. E3 will appear.
Dial right to third number, 90. Stop. OP will appear.
3. Dial right to retract the lock bolt.