Manual

5. Setting up the equipment
Connect the PPM or SBUS-output of the radio to the RC-input of the autopilot as
shown
If your receiver does not have a PPM or SBUS output, you can connect it via PPM
encoder, described in detail here.
Further, apply power to the autopilot, and the receiver itself must be turned on.
Note that some receivers, especially those with telemetry, consume enough power to
feed through the RC port of the autopilot, so that the autopilot can reboot. Therefore,
it is recommended to connect a separate power supply to the receiver, or to feed it
through the free servo outputs of the autopilot, having previously connected BEC to
them from the motor regulators, if any, or by a separate power source!
To calibrate the equipment:
• connect the autopilot with the receiver to the PC via the USB port and press the
"CONNECT" button;
• go to the INITIAL SETUP | Mandatory Hardware | Radio Calibration
ground
ground
power
signal
power