Manual

25
- If you see on the devices’ panel in the Dashboard that the beacon is colored
orange, it means there are some differences in some of the settings between
beacons. For example, some sensors may be off or some ultrasonic or radio
settings may be different. You can change the settings for sensors manually by
clicking on the panel on the upper right corner of the Dashboard to change the
cells from gray to green to turn on sensor. It is recommended that the default
settings on all beacons and the modem be used if this is your first time using the
system
- After you freeze the map of stationary beacons, wake up the mobile beacon. After
it wakes up, it will be traceable in 5-7 seconds
- The system is now fully operational
- In the dashboard, you can upload a picture / map of your room. When the picture
is loaded, you can drag the beacons to the points where they are actually located.
After dragging two beacons, the picture with beacons will be combined in scale.
Use the "Substrate" button on the top toolbar