Manual

• Connect modem to your PC
• Run the Dashboard
• On the map, the program should have beacons, as shown below in the
screenshot.
• Each beacon has its own address from 0 to 99, which can be reassigned. To
do this, go to the right Dashboard parameters panel and choose Device
address (0..99)
• Next, you need one of the beacons and assign a mobile "Hedgehog", to be
installed on the copter. For this purpose, we select one of the beacons in the
bottom panel and in the appeared list of parameters for it, in the line "Hedgehog
mode" we set "Enabled"
• After that, the selected beacon will turn blue (means, it becomes a mobile
beacon or “hedgehog”/”hedge”)