Manual

7. Flight mode setting
Remove the propellers and connect the battery to the copter;
• Set the 3-position control switch to channel 5
• Connect the copter to the PC via the USB port and press the "CONNECT" button;
Then go to the INITIAL SETUP | Mandatory Hardware | Flight Modes
When switching the three-position switch, various flight modes will be highlighted in
green. Select your flight mode for each switch position. For example, for:
• In the upper position, set "Stabilize" (the flight is in fully manual mode), the copter
ignores the navigation system and only holds the horizon.
• Middle position "PosHold" (when releasing the stick "Pich-Roll", the stick of gas
in the middle of the copter hangs in place, at a certain height, relying on data from
the Marvelmind navigation system)
•
• The lower position "Auto" gives the command to execute the flight task (flying by
points).
•
• Click the "Save Modes" button