Manual

16
5. Setting up the system
5.1 First setup of your device
- The steps below describe the very first time you set up of the system.
- Unpack the system. Watch the help video: https://youtu.be/IyXB3UXHdeQ
Note that the video is shot for the previous hardware (HW) version (4.5)
- Check that your boards charged; see that all switches on the beacons are in
the correct position (Power = ON; DFU = OFF). See the paragraph DIP switch
modes
- Press the RESET button on each beacon. If LED 2 is not blinking, it means
your board turned off or discharged. Check the position of the DIP switch again
or charge the beacon via USB