Manual

15
4.6 DIP switch modes
1) Power = OFF, DFU = OFF: Charging is possible; beacon disconnected from
internal battery. This mode recommended if you want to keep the battery fully
charged for a long time and to store the beacon on the shelf (
2) Power = ON, DFU = OFF (pictured below): Normal working mode for the
beacon. The beacon fully powered and will wake up every a few seconds to
monitor radio signals from the modem. Power consumption is still minimal if the
beacon sleeps; the battery can last for many weeks or months. It is recommended
the beacon be kept in this mode and the DIP switch not be touched at all unless
you plan to store the beacon on the shelf. If that’s the case, then mode 1 is
recommended
3) Power = ON, DFU = ON: DFU programming mode. It is used for the initial SW
uploading or when the HEX SW cannot be uploaded from the Dashboard