Operation Manual
13
4. Setting up the system
4.1 The very first setup routine of your device
The routine below describes the very first setup of the system. If you have done that already,
please, jump to the chapter Using the system after the very first setup below.
4.1.1 Unpack the system. Watch the help video: https://youtu.be/IyXB3UXHdeQ. Note that
the video is shot for the previous HW version 4.5
4.1.2 Check that your board is charged; see that all switches on beacons are in the
correct position (Power = ON; DFU = OFF). See paragraph detailed description and
charging
4.1.3 Press Reset button on beacon. If LED2 is not blinking, it means your board is turned
off or discharged. Check the position of DIP switch again or charge via USB; see
appropriate paragraphs for help